hm, i would need a little bit of advice:
do you consider better
variant 1 trim tanks, which are more accurate - without holes connecting port and starboard tank (faster to produce, less material), or
variant 2 trim tanks with interconnecting holes, which adds to final depth of the interior (this extends the process of printing, and amount of material sintered)
also keep in mind that i will have to add periscope stowage tube which goes right through middle and might intersect with these holes, so i might have to exclude one or two of them...
public opinions please?
note, even if a solid piece will be used, i could dress it up with guiding stowage tubes for periscope, air intake mast stowage, and miscellaneous buts and pieces
var1:
![](http://shrani.si/f/1U/u6/27jxvY4g/trim2.jpg)
var2:
![](http://shrani.si/f/3V/di/293MpPiF/trim1.jpg)