AIR > USA - USAAC / AF, Marines/Navy
F6f-3 Hellcat
Greif:
Hi guys, its been a while since I posted any build photos, so I thought I would share a few shots of an 1/48 scale Eduard F6f-3 Hellcat that I recently built. It is an oob build as the kit contained everything I need. I did a bit of superdetailing on the engine, adding a wiring harness made from evergreen tube and copper wire. Other than that the build was pretty straightforward.
Ernest
Rokket:
Beauriful1 NICE and subtle, realistic "new" - clean but wear. Very nice the litle chips. Where are the wiring harness pix, man?!
Greif:
Hi Wink, thank you for the kind words. Unfortunately, I did not take any photos of the engine prior to installing it. Below is a picture of a Sakae engine for a B5N2 Kate that I recently finished - hmm, maybe I should post some pictures of that build ;) - the wiring harness that I scratchbuilt on the engine is very similar to the one on the Hellcat.
Ernest
SG:
Great work indeed Ernest, glad you're back with another beauty. I love the weathering, subtle and very convincing. Congrats!
Greif:
Thank you SG. I plan make a Type IXc build thread when I start the project this spring; so I will have a build more in line with what interests most of the folks on here! :) I have to do a lot of routing and boring to prep the hull, which as you now makes quite the mess, so I do that work in the garage. Right now it is too cold to work out there!
Ernest
--- Quote from: SG on 30 Dec , 2014, 03:51 ---Great work indeed Ernest, glad you're back with another beauty. I love the weathering, subtle and very convincing. Congrats!
--- End quote ---
Navigation
[0] Message Index
[#] Next page
Go to full version